Small Engines
Generator maintenance
by Edward J. Thunderbird
Keep a backup generator ready for the next outage.
DifficultyEasy
Time1 hour
Do it yourself$30 to $80 a year
Hire a pro$150 to $300 a service
Signs of the problem
- Will not start after sitting
- Starts but no power output
- Surging or low voltage
- Oil-low shutdown
How it works
A generator that sits for months is the one most likely to fail when the power goes out. Stale fuel and dead batteries are the top causes. Running it monthly under a load keeps it ready.
Tools and parts
Tools
- Wrenches (Tools Critical)
- Screwdrivers (Tools Critical)
- Spark plug socket
- Plug-in voltage meter
Parts and what they cost
| Part | Typical cost |
|---|---|
| Oil | $6 to $12 |
| Spark plug | $4 to $10 |
| Air filter | $8 to $20 |
| Fuel stabilizer | $8 to $12 |
| Battery (electric start) | $30 to $60 |
Total cost
| Cost | |
|---|---|
| Do it yourself | $30 to $80 a year |
| Hire a pro | $150 to $300 a service |
Costs are typical U.S. prices checked November 18, 2026; they vary by region and change often. Pro prices include labor. Fix Critical is not paid by any store or brand.
Step by step
Safety first
- Never run a generator indoors, in a garage, or near windows: carbon monoxide kills.
- Use a carbon monoxide alarm in the house.
- Never backfeed through a dryer outlet; use a transfer switch or interlock installed by an electrician.
- Refuel only when cool.
- Run it once a month for 20 to 30 minutes with a load (a heater or work light) plugged in.
- Change the oil after the first 20 hours (break-in), then every 50 to 100 hours or each year.
- Replace the spark plug and air filter yearly.
- Keep fuel fresh with stabilizer, or store it with the tank and carburetor empty.
- Keep an electric-start battery on a battery maintainer.
- Check the output with a plug-in meter: about 120 volts and 60 Hz.
Maintenance: keep it from happening again
- Monthly test run under load.
- Oil change yearly or every 50 to 100 hours.
- Fresh fuel or stabilizer always.
When to call a pro
No output voltage (bad AVR or brushes), or for installing a transfer switch or standby generator.