Plumbing

Flush a water heater

by Edward J. Thunderbird

Yearly flush removes sediment, quiets popping and extends tank life.

DifficultyEasy
Time1 hour
Do it yourself$0 to $50
Hire a pro$100 to $250
SignsHow it worksTools and partsStep by stepMaintenanceWhen to call a pro

Signs of the problem

How it works

Minerals and sand settle at the bottom of the tank, insulating the water from the burner or element. Flushing removes them. The anode rod inside the tank rusts away instead of the tank; replacing it every few years adds years to the heater.

Tools and parts

Tools

Parts and what they cost

PartTypical cost
Anode rod$25 to $50
Drain valve (if leaking)$10 to $20
Electric element (if failed)$15 to $35

Total cost

Cost
Do it yourself$0 to $50
Hire a pro$100 to $250

Costs are typical U.S. prices checked November 18, 2026; they vary by region and change often. Pro prices include labor. Fix Critical is not paid by any store or brand.

Step by step

Safety first
  1. Turn the heater off: gas to PILOT, or the breaker off for electric.
  2. Turn off the cold-water supply to the tank. Open a hot faucet in the house.
  3. Attach a hose to the drain valve and run it outside or to a floor drain. Open the valve.
  4. When it slows, turn the cold supply on and off a few times to stir up sediment until the water runs clear.
  5. Close the drain, refill the tank until water flows from the hot faucet, then turn the heat back on.
  6. Every 3 to 5 years, check the anode rod; replace it if it is worn to the wire.

Maintenance: keep it from happening again

When to call a pro

Leaking tank (replace it), gas burner or venting problems, or the smell of gas.

← Fix a leaky faucetAll plumbingThaw and prevent frozen pipes →