Wells and Pumps
Replace a well pressure switch
by Edward J. Thunderbird
The $30 part that fails most often in a well system.
DifficultyModerate
Time30 to 45 minutes
Do it yourself$25 to $45
Hire a pro$150 to $300

Signs of the problem
- Pump will not turn on
- Pump will not shut off
- Burned or pitted contacts
- Switch chatters
How it works
The pressure switch turns the pump on at the cut-in pressure and off at cut-out. Its contacts wear out from arcing. A new one costs about $30 and takes about 30 minutes.
Tools and parts
Tools
- Screwdrivers (Tools Critical)
- Wrenches (Tools Critical)
- Pliers (Tools Critical)
- Non-contact voltage tester
- Thread sealant or Teflon tape
Parts and what they cost
| Part | Typical cost |
|---|---|
| Pressure switch (match 30/50 or 40/60) | $25 to $45 |
Total cost
| Cost | |
|---|---|
| Do it yourself | $25 to $45 |
| Hire a pro | $150 to $300 |
Costs are typical U.S. prices checked November 18, 2026; they vary by region and change often. Pro prices include labor. Fix Critical is not paid by any store or brand.
Step by step
Safety first
- 240 volts: power off and tested before touching wires.
- Keep the cover on whenever power is on.
- Turn off the pump breaker and confirm no voltage with a tester.
- Take a photo of the wiring. Drain the pressure by opening a faucet.
- Disconnect the wires and unscrew the switch from its fitting.
- Clean the small inlet pipe; it often plugs with sediment.
- Wrap the threads with tape, screw on the new switch, and wire it exactly like the photo. Tighten the ground screw.
- Close the faucet, restore power, and check cut-in and cut-out on the gauge.
Maintenance: keep it from happening again
- Look inside the cover yearly for bugs and burned contacts.
When to call a pro
If you are not comfortable working on 240-volt wiring.